King Kutter S-ATV-180-U Manuel d'utilisateur

PO Box 1200305 Commerce DriveWinfield, Alabama 35594www.kingkutter.comS-ATV-180-UOPERATION AND PARTSMANUAL

10EQUIPMENT SAFETY GUIDELINESz Safety of the operator and by standards is one of the main concerns in designing anddeveloping a spreader. However, ev

11IMPORTANT SAFETY INFORMATION------------------------------------------------------------------------------------------------------------THE FOLLOWIN

12DANGER! It is forbidden to climb or to transport some-one when the spreader is in motion. Do not let anyoneinside the hopper for any reason.Keep th

13OPERATION OF THE MACHINEMake a check of the spreader before switching it on. Start to work only if spreader isin perfect condition.Before using the

14SAFETY SETTINGSATTENTION!Be sure that the safety labels are readable. Clean them up using acloth, water and soap. Replace damaged labels placing the

15ATTENTION! - Before use, please check that zerksare adequately greased (see page 21).PULL TYPE SPREADER USEATTENTION! - During the use of the spread

16AdjustmentsIt is not possible to have an exact spreading chart for equipment that makes use ofthe centrifugal force principle, the distributed quant

17HOW TO ADJUST THE SPREADINGThe material spreading is regulated through the regulation lever that moves theopening section on the bottom of the hoppe

18HOPPER LOADINGIt is advised not to load the hopper manually but by using a lift or suitablemechanical means.ATTENTION! The hopper must be loaded on

19Various ways exist to spread the material in the field. One of the simplestmethods is, as follows:Position spreader at the beginng of the field you

20SPREADING MISTAKESMistakes of use- Drive speed;- incorrect spreading width;- The spreading disc is not in a horizontal position compared to the land

21LUBRICATIONBefore every use and after every 8 hours of use, grease the spreader. Be sure that thegrease zerks are clean from dirt and debris before

22Ref.No.Part NamePart Number1 Hopper 9001242Lower Agitator KitRight Hand Shutter Lever - LongLeft Hand Shutter Lever - LongLeft Hand Lever Tie RodShu

Ref.No.Part NamePart Number1 Gear Box 9001252Tire 16 x 6.50-8Right Axle1-7/8” Ball HitchTow Bar for 1-7/8” HitchTongue Rod9001269001279001281951699001

1. Limited Warranty.King Kutter, Inc. (“King Kutter”), P.O. Box 1200, Winfield, Alabama 35594, warrants to the original retailpurchaser (“Purchaser”)

3TO THE PURCHASERThis manual contains valuable information about yournew King Kutter ATV Spreader. It has been carefully pre-pared to give you helpful

4It is the purchaser and/or operator’s responsibility to….zzzzz Read and understand the information contained inthis manual.zzzzz Operate, lubricate,

5CONTENTSITEM PAGEGeneral Information ...6Technical Data ...

6INFORMATION ON THE MACHINEThe models in this manual have been designed and made exclusively allowingthe distribution of solid, granular fertilizers a

7The feeding of the disc is by gravity through an opening located at the bottom ofthe hopper, inside of which a mix/agitator is applied, in order to p

8A. REGULATING LEVERB. HOPPERC. DISTRIBUTOR VANESD. SPREADER DISCE. STEEL FRAMEF. TIRESG. ROD FOR TONGUE ADJUSTMENTH. TONGUEI. 1-7/8” BALL HITCHTECH

9SIGNAL WORDS:The signal words DANGER, WARNING and CAUTION are used with thesafety messages in this manual and with each safety signs. They aredefine